Bond ingredients: Acrylates/Ethylhexyl Acrylate Copolymer, Water (Eau,Aqua), Butylene Glycol, Alcohol Denat., AMP-Acrylates Copolymer, Phenoxyethanol, Citric Acid, Sorbitol, Sodium Carbonate, Ceteareth-25, Cellulose Gum, Ethylhexylglycerin, Carbon Black (CI77266)

Seal Ingredients: Cyclopentasiloxane, Cyclohexasiloxane, Trimethylsiloxysilicate, Water (Eau,Aqua), VP/Eicosene Copolymer, Polypropylsilsesquioxane, Glycerin, Hydrogenated Polyisobutene, Hydroxypropylcellulose, Polysorbate 20, Phenoxyethanol, Ethylhexylglycerin, Tocopheryl Acetate 
Remover ingredients: Butyrolactone, Hydroxypropylcellulose, Glycerin

PREP: PLEASE READ THOROUGHLY BEFORE STARTING APPLICATION. BE VERY CAREFUL NOT TO GET ANY BOND, SEAL, or REMOVER in your EYES. 

1. Start with clean lashes. Do not apply mascara before or after using Seamless. 
2. For best results, curl lashes before application.
3. Apply a light coat of BOND at base and about halfway up the UNDERSIDE of your lashes.  Avoid getting BOND all the way to the lash tips. Do one section at a time as BOND dries quickly. 
4. Apply UNDIES underneath the base of your natural lashes slightly away from waterline. UNDIES should be applied lash to lash, avoiding skin contact. Start from outer corner and work inward. Placement of UNDIES should be right next to each other to achieve a seamless look. 
5. Use APPLICATOR to FUSE lashes together after application. Squeeze lashes at the base to ensure they are secure 
6. Apply a thin coat of SEAL under the UNDIES at the base. This eliminates any sticky residue and holds UNDIES in place.

DAILY MAINTENANCE: 

1. Do not get UNDIES wet for 24 hours 
2. Be sure to fuse lashes everyday with the applicator to keep UNDIES secure! 

TO REMOVE: 

1. Dab & roll REMOVER on top side of lashes and underside. Wait 10-15 seconds and slide off lashes with fingers.  
2. BE CARFUL NOT to get REMOVER in eyes!