Directions:

1. Make sure feet are clean and dry.
2. Be sure the Roller Head is firmly placed into the Unit before use.
3. Slide the switch up one time to the LO position to turn ON the Unit.
4. The Unit will begin on Low Speed Start on the sole or ball of your foot, holding the Roller Head gently against your skin. NOTE: Do not press the Roller Head hard against your skin, as it will affect the speed and results.
5. Move the Unit in a slow, back and forth motion around the sole or ball of your foot in 2-3 second increments. NOTE: Using the Finishing Touch Flawless Pedi™ should not cause pain or discomfort. If you feel pain or discomfort, discontinue use immediately.
6. Stop and check to see if you have achieved desired result. If not, go over the area again or increase speed to the HI position for very rough and/or callused skin.
7. To turn OFF the Unit, slide the switch down to OFF.
8. Once complete, take a damp cloth and wipe the area to remove any dead skin or residue. Be sure to dry promptly.

• Before first use, fully charge the unit.
• Use on clean, dry skin. No water, soap or creams should be used.
• Use either over a garbage or towel as there may be some dead skin or residue from use.
• Always start on the lower speed and then increase as needed.
• Do not press the roller head hard against your skin.
• Start on LOW speed and then after becoming comfortable with the Unit, you can advance to the HIGH speed.