For Curing Gel Extensions:

1. Nail Prep: Cut, file, and buff your natural nails. Lightly clean and remove cuticle area. Remove any dust and debris on nails and skin by wiping the nail clean with 91% isopropyl alcohol or gel cleaner solution.
2. Pro Tip: Size tips to all nails BEFORE proceeding with product application. Tips should fit the nail sidewall to sidewall naturally without applying pressure. If you are in between sizes, size up and file sides as necessary.
3. Apply Acid Free Primer to all nails.
4. Apply a thin layer of Builder Gel to all nails. Cure LED gel products for 60 seconds or 2 minutes
for UV gel products. 
5. Using the acid-free primer brush, rub a small amount of primer onto the inside of the pre etched nail tip.
6. Apply a layer of Builder Gel to the inside of the pre-etched tip where it contacts the natural nail. Press the gel tip to the nail at an angle starting at the base of the nail and slowly push downward, allowing the gel to spread to the free edge of the nail.
7. While holding down the tip in place, flash cure for 15-20 seconds. Make sure to hold securely to unsure no bubbles appear under the nail.
8. Cure all nails under UV/LED light. 60 seconds for LED gel products or 2 minutes for UV gel products after flash curing. 
9. Pro Tip: Wipe any sticky gel on the underside or edge of the nail/tip with a brush dipped in gel cleaner or 91%
isopropyl alcohol.
10. Once nails are cured and secured, file and shape the tips to your liking.
11. Proceed with your gel manicure. NOTE: For best results, complete your manicure with gel polish. You can proceed with dip powder, but it is best if your dip manicure is applied in very thin coats. No sculpting should be needed.
12. Seal and protect your manicure with topcoat and cure for 90 seconds in a UV/LED lamp.
 

General Operation Instructions:
1.    Press once to start the 30 second countdown, the LED lights ups and turns off automatically after 30 seconds, press again to turn off the LED. 
2.    Press and hold for 5 seconds to keep the LED light on until the battery runs out and LED turns off; press again to turn the LED off.